Wood Veneer Dryer Machinery
Shine wood veneer dryer machinery provides you with a one-stop solution. The dried veneer has uniform moisture content, is flat, has no wrinkles or end ripples, no cracks, and has a good surface glued state.
The biomass burner can directly burn waste wood which not only decrease drying cost,but also avoild the accumulation of waste wood.Low carbon and environmental protection.
Wood Veneer Dryer Machinery
The wood veneer dryer machinery is driven by the chain to run the upper and lower rollers, relying on the upper roller to press the veneer to run. Biomass combustion furnace is used to burn wood chips, waste wood and other materials at high temperature. Materials boil and fluidize in the burner to provide heat energy to the veneer dryer.For process the surface veneer and long core veneer, this veneer dryer can avoid the break of the veneer, then can raise the veneer utilization ratio and production output.
The wood veneer dryer machinery can be customized for you according to your actual situation. The newly upgraded dryer has reduced power and power consumption, saving electricity bills. Manual, semi-automatic and fully automatic configurations are available for you to choose from. Choose Shine to provide you with a full set of service solutions.
Product Parameter of Wood Veneer Dryer Machinery
Model No | GTH30-52 |
Working Width | 3m |
Deck | 2 |
Roller material | Q235B, φ89 steel pipe |
Heating area length | 48m |
Cooling area length | 4m |
Veneer thickness | 0.8-8mm |
Veneer water moisture | Fresh veneer to about 10% |
Heating material & drying temperature | Waste wood, 140-200°C adjustable. Temperature control accuracy ±5°C. There is automatic temperature control and speed regulation system, which can guarantee the moisture content is consistent. |
Drying capacity (m³/24h) | 75-85cbm |
Veneer transport speed | 5-22m/min，16A chain |
Hot air blower | Power:5.5KW（12pc） |
Traction motor | Power: 7.5KW，frequency control（2pc） |
Cold air blower | Power: 5.5KW（1pc） |
Air intake fan | Power : 11KW（2pc） |
6 ton biomass burner | Power: 16.5KW |
Total power | 125KW |
Actual electricity consumption | About 88kwh per hour |
Covered Space of the whole machine | 58M X 9M X 3M |
Customer Case
Exhibition
The Factory
Our Services
Pre-sale services:
1) Provide the free consultation of all veneer production line
2) According to the clients' special requirement, offering the reasonable plan and free design to help to select the equipment.
3) Welcome to visit our factory.
Services during the sales:
1) Inspect the machine before leaving the factory.
2) Oversea install and debug the equipment.
3) Train the first-line operator.
After sale services:
1) 24 hours online service.
2) Provide the VIDEO with Install and debug the equipment.
3) Provide technical exchanging（Technical phone：+8615806625431）Door to door service is possible.
