Plywood Drying Machine
Type: Biomass Veneer Dryer
Working Width: 3m
Veneer thickness: 0.8-8mm
Heating Area Length: 44m
Drying capacity (m³/day) : 70-80
Heat Source: Biomass Burner (Other options available)
24 hours online service（WhatsApp：15806625431)
Plywood Drying Machine
Shine plywood drying machine is of high quality and efficiency and is the best choice for plywood veneer drying. Roller type wood veneer dryer can keep the veneer smooth and has uniform moisture content after drying. The output of veneer with the thickness of 0.8-8mm through veneer drying machine. Waste wood and other waste bark can be used as the fuels for thiccoreveneer drying line, saving the cost significantly. The composite cost is about only USD 6-12/cubic meter. Our biomass burner of veneer dryer machine can use waste wood as fuel, which is environmental,saving energy,reduce cost and also there is no any smoke.
Working Principle of Plywood Drying Machine
working principle is veneer veneer drying technology in steel tube under the clamping roller, two by preheating the oven temperature to 140, and then enter the upper and lower roller and through the hot air pipe to the single board upside down between hot high pressure blowing for quick dry, so you can make the veneer smooth moisture content after drying of uniform, And it has the characteristics of high temperature roller and wet veneer direct contact heat transfer, high thermal efficiency and small thermal loss.
Shine's veneer dryer can work 24 hours a day and only needs 4-5 laborers, which greatly saves labor costs. After drying, the moisture content of the veneer is even and smooth. Machine failure rate is low, reducing downtime. The power consumption of the whole machine is 35% lower than that of traditional dryers.
Application fields:
It is suitable for woodworking enterprises to produce rotary cut veneer, plywood, furniture, formwork and floor.
Product Parameters of Plywood Drying Machine
Model No | GTH30-48 |
Working Width | 3m |
Deck | 2 |
Roller material | Q235B, φ89 steel pipe |
Heating area length | 44m |
Cooling area length | 4m |
Veneer thickness | 0.8-8mm |
Veneer water moisture | Fresh veneer to about 10% |
Heating material & drying temperature | Waste wood, 140-200°C adjustable. Temperature control accuracy ±5°C. There is automatic temperature control and speed regulation system, which can guarantee the moisture content is consistent. |
Drying capacity (m³/24h) | 70-80cbm |
Veneer transport speed | 5-22m/min，16A chain |
Hot air blower | Power:5.5KW（11pc） |
Traction motor | Power: 7.5KW，frequency control（2pc） |
Cold air blower | Power: 5.5KW（1pc） |
Air intake fan | Power : 11KW（2pc） |
6 ton biomass burner | Power: 16.5KW |
Total power | 119.5KW |
Actual electricity consumption | About 83.65kwh per hour |
Covered Space of the whole machine | 50M X 9M X 3M |
Certification
Our Factory
Customer Visiting
Our Services
Pre-sale services:
1) Provide the free consultation of all plywood machinery
2) According to the clients' special requirement, offering the reasonable plan and free design to help to select the equipment.
3) Welcome to visit our factory
Services during the sales:
1) Inspect the machine before leaving the factory.
2) Oversea install and debug the equipment
3) Train the first-line operator.
After sale services:
1) 24 hours online service
2) Provide the VIDEO with Install and debug the equipment
3) Provide technical exchanging（Technical phone：++8615806625431）Door to door service is possible
