How to avoid the problem of veneer dryer jamming？

Many people may encounter the problem of veneer jamming when using the roller veneer dryer. In order to avoid this problem, the following suggestions can be taken: First, keep the equipment clean, clean the dust collector and exhaust duct, and minimize the accumulation of dust; second, do a good job of adjusting the equipment, reduce the friction and wear of the equipment, and regularly check the status of the roller bearings; finally, pay attention to the control of drying temperature and humidity to avoid excessive temperature and humidity, which will cause veneer deformation and jamming. Also, when placing the veneer, do not place it diagonally, especially when it is tilted more than 45 degrees, and do not place it too close to the edge, and do not dry very poor and rotten third-level veneers. The above are some small suggestions for avoiding jamming.