Company News
News Center
The Vertical Veneer Dryer purchased by our customer in Cote d'Ivoire has been produced and is being prepared for shipment. This equipment has a daily output of more than 30 cubic meters. It is equipped with a built-in furnace, occupies a small area, and saves labor. If you are also inspecting
2024/05/16 09:43
Recently, our Peruvian customers came to visit our factory. A test run of the veneer dryer was carried out on-site to allow the customers to inspect the equipment at close range. Our sales manager gave an explanation. Finally, the customer was satisfied with the dryer equipment. Very recognized and
2024/04/30 08:45
Shine small vertical dryer covers an area of 20 meters. It uses a built-in furnace to directly burn tree branches, etc., saving labor (only three people are needed), saving energy and low cost. It can dry 1.5 cubic meters per hour, which is very suitable for bosses who are drying boards. If you
2024/04/25 10:07
The 3.75-meter-wide and 56-meter-long veneer dryer purchased by our customer in Chonburi, Thailand, has been installed. Our engineers will guide the installation. It is equipped with a 10-ton biomass burner, which can directly burn bark and save money. To reduce fuel costs, the new axial flow fan
2024/04/18 11:24
The five vertical veneer dryers purchased by our Myanmar customers have now been installed and running. Our engineers will guide the installation. The output is about 1.2-1.3 cubic meters per hour. They are equipped with built-in furnaces, occupy a small area, and are cheap, requires less labor and
2024/04/08 11:22
The 2 deck veneer dryer purchased by our Thai customer has been installed and will be ready for trial operation in the near future. If you want to see the case site, please contact us!
2024/03/28 10:19
Customer site installation is a 2 deck wood roller dryer, equipped with our biomass burning furnace, can directly burn waste bark, in addition to the customer's own installation of dust removal device, environmental protection problems are basically solved, now has been installed, ready for
2024/03/21 09:01
Shine veneer dryer mainly has the following features:1. The power of the whole machine is reduced by 30%The hot air fan and cold air fan of the veneer dryer adopt new axial flow fans, which not only fully guarantees the air volume required for drying, but also reduces the total installed power,
2024/03/19 11:33
Our Zimbabwean customer purchased a 2 deck 30 m with 4 tons of burning machine is currently in operation, the customer is used to dry pine and eucalyptus 2.45mm thick, the feedback is very good, the later expansion of production capacity will continue to purchase. We are very grateful to our
2024/03/14 09:43
The 2 deck 56 m veneer dryer purchased by our Thai customer is being installed by our engineers. This equipment is equipped with a 10-ton biomass burner, with a width of 3.75 meters. It uses a new axial flow fan to save energy. Save electricity. If you want to see the case site, please contact us !
2024/03/12 14:54
The 2 deck 48 m veneer dryer and 6-ton burner purchased by our customers in Phechabun Province, Thailand, are being installed. Our engineers went to the customer's factory to guide the installation, and the engineers returned only after the equipment could be used normally. The customer used
2024/03/07 09:46
The shine veneer dryer has the characteristics of large drying output, good effect, and easy maintenance. It has been unanimously recognized by customers and has been widely used. However, some customers always report that the efficiency of the wood chip drying equipment is not high. This is due to
2024/03/05 09:46
