Veneer Jet Dryer Machine
Type: Biomass Veneer Dryer
Working Width: 3m
Veneer thickness: 0.8-8mm
Heating Area Length: 24m
Drying capacity (m³/day) : 80-90
Veneer Water Moisture: Fresh veneer to about 0-15%
Cost: 6-12$/m3 (Labor+Fuel+Electricity)
Heat Source: Biomass Burner (Other options available)
Veneer Jet Dryer Machine
Veneer jet dryer machine has the advantages of simple operation,safety and practicality, stable operation and easy maintenance ,hot pressing-leveling-drying are finished at the same time &and others.The roller dryer machine is mainly used in plywood industry, and used to remove moisture from the veneer.The dryer machine can effectively use various resources and occupy a small area.The roller dryer machine can be divided into two parts: heating section and cooling section.The heat medium can be oil and heat steam.
working principle：
working principle is veneer veneer drying technology in steel tube under the clamping roller, two by preheating the oven temperature to 140, and then enter the upper and lower roller and through the hot air pipe to the single board upside down between hot high pressure blowing for quick dry, so you can make the veneer smooth moisture content after drying of uniform, And it has the characteristics of high temperature roller and wet veneer direct contact heat transfer, high thermal efficiency and small thermal loss.
Product Parameters of Veneer Jet Dryer Machine
Model No | GTH30-28 |
Working Width | 3.0m |
Deck | 4 |
Roller material | Q235B, φ102 special shaft tube |
Heating area length | 24m |
Cooling area length | 4m |
Veneer thickness and size | 0.8-8mm |
Veneer water moisture | Fresh veneer to about 8-10% |
Heating material & drying temperature | Waste wood, 140-200°C adjustable. Temperature control accuracy ±5°C. There is automatic temperature control and speed regulation system, which can guarantee the moisture content is consistent. |
Drying capacity (m³/day) | 80-85 |
Veneer transport speed | 5-22m/min，16A chain |
Hot air blower | Power: 4KW（24pc） |
Traction motor | Power: 5.5KW，frequency control（4pc） |
Cold air blower | Power: 4KW（8pc） |
Air intake fan | Power: 11KW（1pc） |
10 ton biomass burner | Power: 16.5KW |
Total power | 161.5KW |
Actual electricity consumption | About 114kwh per hour |
Overall Dimension(L*W*H) | 43m×12m×3.5m |
Customer Case
The installation
The Factory
Packaging & Shipping
