Plywood Veneer Drying

Plywood veneer drying is the most effective veneer drying machine. Hot air recycling inside the veneer dryer greatly reduces the operating cost of the enterprise, improves the quality of the veneer, and increases the veneer drying capacity. After drying, the dried veneer is flat and the moisture content is uniform. When the veneer is located between the two groups of rollers, the transverse shrinkage can be free, the crack is reduced, and the veneer drying quality is good. In the benign physical process of wood shrinkage, the veneer does not warp, the damage rate is low, and the rate of the finished product is high.

  Contact Now
Product Details

Plywood Veneer Drying


shine veneer dryer machine are renowned for consistently producing high quality veneer with a uniform dry moisture content, an aesthetic appearance, and that is supple enough to minimize damage during stacking. Our dryers offer the highest efficiency, using the least amount of thermal energy and producing a minimum of volume dryer exhaust. 


Plywood Veneer Drying


Our roller dryer can also be heated by a steam boiler, gas burner, or thermal oil heater. So in the event, the customer has a gas line in the factory, our roller dryer can be heated by using the gas burner to burn gas to heat the thermal oil. And so the thermal oil running inside the radiators and hot air emitted into the face and back of the veneer.


Plywood Veneer Drying


Product Parameter of Plywood Veneer Drying


Model No

GTH30-56

Working Width

3m

Deck

2

Roller material

Q235B, φ89 steel pipe

Heating area length

52m

Cooling area length

4m

Veneer thickness

0.8-8mm  

Veneer water moisture

Fresh veneer to about 10%

Heating material & drying temperature

Waste wood, 140-200°C adjustable. Temperature control accuracy ±5°C. There is automatic temperature control and speed regulation system, which can guarantee the moisture content is consistent.

Drying capacity (m³/24h)

85-95cbm  

Veneer transport speed

5-22m/min,16A chain

Hot air blower

Power:5.5KW(13pc)

Traction motor

Power: 7.5KW,frequency control(2pc)

Cold air blower

Power: 5.5KW(1pc)

Air intake fan

Power : 15KW(2pc)

6 ton biomass burner

Power: 16.5KW

Total power

138.5KW

Actual electricity consumption

About 97kwh per hour

Covered Space of the whole machine

62M X 9M X 3M


Plywood Veneer Drying


Customer Case


Customer Case


Certification


Certification


The Factory


Factory


Our Services


Pre-sale services:

1) Provide the free consultation of all plywood production line

2) According to the clients' special requirement, offering the reasonable plan and free design to help to select the equipment.

3) Welcome to visit our factory.

Services during the sales:

1) Inspect the machine before leaving the factory.

2) Oversea install and debug the equipment.

3) Train the first-line operator.

After sale services:

1) 24 hours online service.

2) Provide the VIDEO with Install and debug the equipment.

3) Provide technical exchanging(Technical phone:+8615806625431)Door to door service is possible.

Send your message to us
x